Honeywell HBD2PR1 User Manual page 59

Table 3-10 TCI/IP Configuration
Parameter Function
IP Address Use the keyboard to enter the corresponding number to modify the
IP Address, and then set the corresponding Subnet Mask and
Default Gateway.
Preferred DNS Enter the preferred DNS IP address.
Server
Alternate DNS Enter an alternate DNS IP address.
Server
Enable ARP/Ping If you know the camera's MAC address, then use the ARP/Ping
to set IP Address command to modify or set the camera's IP address.
Service
Before operating the camera, please ensure that the network
camera and the PC are in the same LAN. This function is On by
default.
To enable ARP/Ping to set the IP address service:
1. Get an IP address. Set the network camera and the PC in the
same LAN.
2. Get the physical address from the label on the network camera.
3. Go to the Run interface, and then enter the following
commands:
arp
ping
Such as:
ping
4. Reboot the camera.
You can see that the setup was successful if you can see that
there is output information such as Reply from
192.168.0.125... from the command output lines.
5. Close the command line.
6. Open the browser and then enter http://<IP
Click Enter, and then you should have access.
-s <IP Address> <MAC>
-l 480 -t <IP Address>
arp -s 192.168.0.125
-l 480 -t 192.168.0.125
Web Operation | 59
11-40-8c-18-10-11
address>.
800-18161 - A - 06/2014