Table of Contents
Advertisement
Handlebar display
Mount LED Display or Cycle Analyst on Handlebar
Standard eZee Kits include an LED battery indicator. Note that the ON/OFF switch
on the LED indicator is not wired up to anything. The Cycle Analyst upgrade
option provides more detailed information on your ebike dashboard and uses
the same connector.
If your Cycle Analyst was purchased as an upgrade option, the configuration
settings are correctly set; if your Cycle Analyst was purchased separately,
adjust your configuration settings according to the specifications section
on page 10.
Wiring
The electrical components of the eZee kit have all been terminated with mating
and unambiguous connectors between the controller and each of the
components. The throttle, battery pack, and motor must all be plugged into the
motor controller for the kit to function. The display and pedal assist
components are both optional.
Run ebike wires tidily along your bike frame and secure with cable
ties: avoid over tightening so they do not sever
Cable ties
- OR -
Slack to allow handlebars to turn corners
without tugging on cable connectors
Cable tie
Motor connector housing
(details on next page)
Advertisement
Table of Contents
