Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Renaissance eZee
Summary of Contents for Renaissance eZee
- Page 1 Renaissance Bicycle Company eZee Kit Installation Guide The eZee electric bicycle conversion kit contains a hub motor, rechargeable battery, and all the other components required to bring electric power to your ride. Installation requires basic bike tools and takes between 30 minutes and 2 hours.
- Page 2 Kit Installation Guide Version 2.3 Copyright © 2010 Renaissance Bicycle Company www.ebikes.ca...
-
Page 3: Motor Controller
Key Electronic Parts of Your System Motor Controller 3-pin connector The Controller interfaces all to throttle the electrical components of 4-pin connector, for optional your ebike and regulates the pedal assist sensor power of your motor 6-pin connector to LED display or Cycle Analyst 50cm Anderson Connectors... - Page 4 Hub Motor Installation Installation without disc Install with disc -OR- Install disc rotor If disc not required, then depending on supplied onto hub motor using hardware either a) install washers under set of screws provided xmm screws or b) install shorter xmm set of screws Remove original front wheel from bicycle Right...
- Page 5 Securing and aligning the axle hardware Tightening assembly must sit flat Spacer washer doesn’t fit Spacer washer missing and large in quick release recess, washer not sitting flat because requires filing the dropout it is hitting a quick release lip Tighten your axle nut firmly so the axle does not spin out and your wheel does not fall off (approx.
- Page 6 Motor Controller & Battery Option 1: Controller inside battery bag Shift to rear to avoid foot collision Battery bag hangs on rear pannier rack If you plan to ride in hot weather, without pedaling up steep hills, etc., mount your controller outside of the - OR - battery bag to prevent thermal shutdown Option 2: Controller mounted on...
-
Page 7: Handlebar Display
Mount LED Display or Cycle Analyst on Handlebar - OR - Standard eZee Kits include an LED battery indicator. Note that the ON/OFF switch on the LED indicator is not wired up to anything. The Cycle Analyst upgrade option provides more detailed information on your ebike dashboard and uses the same connector. -
Page 8: Charging Your Battery
Attach connector case to Connect bullet and hall connectors front fork using cable ties and place inside: match yellow, green, and blue wire colors Cable ties Wet weather tip: If you have exposed connectors that do not need to be unplugged, use silicone tape or heat shrink to wrap around the connections. -
Page 9: Warranty
RPM so that it will also achieve 32 kph. If the eZee kit is powered from a 48V battery pack, then the top speed will be increased by 30%, to just over 40 km/hr. Similarly, the speed can be reduced to about 20 km/hr by using a 24V battery. - Page 10 Q. Which batteries can I use with my eZee hub motor kit? A. Renaissance Bicycle Company eZee Kits will work with just about any 24, 36, 48V battery pack that can deliver 20Amps. Q. I have twist grip gear shifters, or I am left handed, can I use another throttle? A.
-
Page 11: Specifications
Specifications CONTROLLER BATTERY Voltage 37 V 60 V Max Voltage Amp Hours 9.0 Ah Min Voltage 20 V Charger Current Waterproof Charger Voltage 42 V 20 A Current Limit Chemistry Lithium Manganese Weight 0.32 kg Weight 4.53 kg 9.8 x 6.5 cm Dimensions Dimensions 37.5 x 7.0 cm...