Universal Remote System Operation - Cadillac 2010 SRX Owner's Manual

4-52 Instruments and Controls
If you live in Canada, or you are
having difficulty programming a
gate operator or garage door
opener by using the Programming
Universal Home Remote
procedures, regardless of where
you live, replace Step 2 under
Programming Universal Home
Remote with the following:
2. Continue to press and hold the
Universal Home Remote button
while you press and release every
two seconds (cycle) the hand-held
transmitter button until the
frequency signal has been
successfully accepted by the
Universal Home Remote. The
Universal Home Remote indicator
light will flash slowly at first and then
rapidly. Proceed with Step 3 under
Programming Universal Home
Remote to complete.
Universal Remote
System Operation
Using Universal Home Remote
Press and hold the appropriate
Universal Home Remote button for
at least half of a second. The
indicator light will come on while
the signal is being transmitted.
Erasing Universal Home
Remote Buttons
All programmed buttons should be
erased when the vehicle is sold or
the lease ends.
To erase all programmed buttons on
the Universal Home Remote device:
1. Press and hold down the two
outside buttons until the
indicator light begins to flash,
after 10 seconds.
2. Release both buttons.
Reprogramming a Single
Universal Home Remote
Button
To reprogram any of the three
Universal Home Remote buttons:
1. Press and hold the desired
Universal Home Remote button.
Do not release the button.
2. The indicator light will begin to
flash after 20 seconds. Without
releasing the button, proceed
with Step 1 of the section
Programming Universal Home
Remote .
If you have questions or need
help programming the Universal
Home Remote System, call
1 800 355 3515 or go to
www.homelink.com. You may
also call the customer assistance
phone number under Customer
Assistance Offices on page 12 3.