Panasonic NE-3280 Service Manual page 23

carefully remove all solder from the terminal pins of the low voltage
transformer and/or power relays.
NOTE
Do not use a soldering iron or desoldering tool of more than 30 watts on DPC contacts.
2. With all the terminal pins cleaned and separated from DPC contacts,
remove the defective transformer/power relays and install new
transformer/power relays making sure all terminal pins are inserted
completely. Resolder all terminal contacts carefully.
14.4. Disassembly of door assembly
1. Detach the door spring ends from right and left door arms.
2. Remove the arm lever right and left by removing 2 screws each on both
sides.
3. Remove the sashes right and left by removing 1 screw each on both
sides.
4. By holding the door assembly, remove the right and left sides door
hinge pins. The door assembly is now free from the oven.
5. Remove 3 screws holding the door A.
6. Remove the door C by using a flat screwdriver as figure.
7. Remove 4 screws holding door handle.
8. Separate door A and door E.
9. Remove the door arms by removing 1 pin each on both sides.
Created with novaPDF Printer (www.novaPDF.com). Please register to remove this message.
22