Chapter 2 Hardware Installation; Panel Layout - Gnet IP104 User Manual

2.1 Panel Layout (your product may need to be modified)
2.1.1. Front Panel
LED:
LED Function
System status
M1&M2
indicators
WAN port
WAN
activity
Link/Act.
Link status
1~4
Speed
Data Rate
10/100
Port:
To reset system settings to factory defaults, please follow the steps:
RESET
1. Power off the device,
2. Press the reset button and hold,
3. Power on the device,
4. Keep the button pressed about 5 seconds,
5. Release the button,
6. Watch the M1 LED and M2 LEDs, they will flash 8 times and then
M1 flash once per second.

Chapter 2 Hardware Installation

Figure 2-1 Front Panel
Color Status
Orange Blinking
On
Green
Blinking
On
Green
Blinking
Green On
Description
M1 is flashed once per second to
indicate system is alive. When
system is busy, M2 is lighted.
The WAN port is linked.
The WAN port is sending or
receiving data.
An active station is connected to
the corresponding LAN port.
The corresponding LAN port is
sending or receiving data.
Data is transmitting in 100Mbps
on the corresponding LAN port.