Procedure For Hardware Installation - Gnet IP104 User Manual

2.3 Procedure for Hardware Installation

1. Setup LAN connection: connect an Ethernet cable from your computer's Ethernet
port to one of the LAN ports of this product.
2. Setup WAN connection: prepare an Ethernet cable for connecting this product to
your cable/xDSL modem or Ethernet backbone.
3. Power on:
Connecting the power cord to power inlet and turning the power switch on, this
product will automatically enter the self-test phase. When it is in the self-test phase,
the indicators M1 and M2 will be lighted ON for about 5 seconds, and then M1 and
M2 will be flashed 3 times to indicate that the self-test operation has finished. Finally,
the M1 will be continuously flashed once per second to indicate that this product is in
normal operation.