NYSW Fifth Avenue Series 1309L-021GN Quick Setup Manual

NYSW

Step 1: First Time Use- FOLLOW INSTRUCTIONS CAREFULLY!

Please place your watch near a window for no less than 24 hours and a maximum of 48 hours in order to receive
the radio signal. For the best possible reception please place your watch on a flat surface in a face down posi-
tion.
There are other functions that are provided by the manufacturer for your Atomic Watch. You may go through
them in the extended instruction manual enclosed but please go through the "Quick Setup Guide" initially step
by step prior to reading the extended manual .

Step 2: Check the Second-hand position

Make sure the second hand's position is set at 6 or 12 when you take out the watch out of
the packaging.
During shipping the second hand may shift, therefore if the second hand does not point to either 6 O'clock or 12
O'clock, then you need to re-calibrate the second hand to the correct position.
If second-hand points at 6 o'clock
no re-calibration is required
Press S2 (the middle button) once to check if the second-hand stops at either 6 or 12 o'clock position (half
second deviation should be acceptable). If the second-hand does not pause at either the 6 or the 12 o'clock
position, read the "Re-calibrate the second-hand" section of the Quick Guide. For a more detailed explana-
tion, go to the Troubleshooting section of the Extended Instruction Guide.
New York Standard Watch Company
Quick Setup Guide
Fifth Avenue Series - 1309L-021GN
(3 hands Analog-Digital Atomic Watch)
Check position of Second-hand:
OK
S1
S2
Press once
S3
NG
OK
NG
If second-hand points at 12 o'clock
no re-calibration is required
.
www.NewYorkStandardWatch.com
2007 EN
S1
S2
Press once
S3
Page 1