NYSW FIFTH AVENUE SERIES Quick Setup Manual

Hide thumbs Also See for FIFTH AVENUE SERIES:

Step 1: First Time Use- FOLLOW INSTRUCTIONS CAREFULLY!

Please place your watch near a window for no less than 24 hours and a maximum of 48 hours in order to receive the radio signal. For

the best possible reception please place your watch on a ﬂ at surface in a face down position.

There are other functions that are provided by the manufacturer for your Atomic Watch. You may go through them in the extended in-

struction manual enclosed but please go through the "Quick Setup Guide" initially step by step prior to reading the extended manual .

When you take out the watch out of the packaging, please press S1 (upper) button once and see if the second hand's position

will point exactly at 6 O'clock or 12 O'clock.

During shipping the second hand may shift, therefore if the second hand does not point to either 6 O'clock or 12 O'clock, then you

need to re-calibrate the second hand to the correct position.

Press-release S1 once while the watch is running regularly

If the watch received signal during the past 24 hours, the second-hand will pause at 12 o'clock

If the watch didn't receive signal during the past 24 hours, the second-hand will pause at 6 o'clock. Just leave the watch near

a window for over night and check the second-hand position again.

Don't push any button after the second-hand has stopped. Wait until it moves again.

. If the second-hand does not pause at either the 6 or the 12 o'clock position, please read the Procedure to calibrate the shifted

second-hand section in TROUBLESHOOTING section of the Extended Instruction Guide.

New York Standard Watch Company . www.newyorkstandardwatch.com

IM code: M55A

Table of Contents

Do you have a question about the FIFTH AVENUE SERIES and is the answer not in the manual?

Page 1 NYSW Quick Setup Guide IM code: M55A Step 1: First Time Use- FOLLOW INSTRUCTIONS CAREFULLY! Please place your watch near a window for no less than 24 hours and a maximum of 48 hours in order to receive the radio signal. For the best possible reception please place your watch on a ﬂ...
Page 2 NYSW Quick Setup Guide IM code: M55A Step 3: Time Zone Setting (for USA users ONLY! ) Check USA Time Zone Setting Press and release S3 (lower )button once while the watch is running normally. LED light indicates the USA Time Zone setting as below: RED (Stable light) = Paciﬁ...