Table of Contents
Advertisement
3.2 Installation Instructions
After placing MyPBX U500 in a suitable place, please connect the power adapter and all other cables to
complete the installation.
3.2.1 Connection of Ethernet Ports
MyPBX U500 provides two 10/100M adaptive RJ45 Ethernet ports, that is, LAN port and WAN port.
WAN Port Connection
Connect one end of a network cable to the WAN port of MyPBX U500, and the other end to the Ethernet
port of a hub, switch or ADSL modem.
LAN Port Connection
Connect one end of a network cable to the LAN port of MyPBX U500, and the other end to any port of
company's LAN switch/router.
If the LAN port is connected to PC directly (not via a switch), please use cross-over cable.
3.2.2 Connection of FXO/GSM/UMTS/BRI ports
MyPBX U500 supports various outside lines (e.g. FXO, GSM/UMTS, or BRI). Below are the connection
instructions of each kind of outside line taking the device installed with 2 FXO ports, 2 GSM ports, and 2 BRI
ports as an example.
1. Connection of FXO ports
The FXO port could be connected to the PSTN line or the FXS port of a traditional PBX with a phone line.
For instance, if No.2 and No.4 connectors are FXO ports, the connection could be depicted as below:
2. Connection of GSM/UMTS ports
http://www.yeastar.com
Figure 3-1 Connection of FXO ports
MyPBX U500 Installation Guide
7/13
Hide quick links:
Advertisement
Table of Contents
