Advertisement
I T° Set: I
1. Check Lint Filter Before Each Load
5, Select Cycle
Be surethelintfilterisclean and properlyreplaced. Neverusethe
Dryer automaticallyselects PERMA PRESS.
If you wish to
dryer withoutthe Lint Filterin position,
change the cycle, use:
Note: Among otherthings,failureto clean the lintfilterregularly
Automatic Cycles- selectonthe basisoffabric. You arealso
will cause the dryer to take longerto dry the clothes,
able to select MORE DRY cr LESS DRY and WRINKLE
OUT.
2. Load The Dryer
Manual Options - TIMED DRY. You may select from 15
Generally, a washer load is a dryer load. However, the drying load
minutes (TOUCH UP) to 110 minutes. You may also select
should be sorted by weight, texture and bulk of fabrics.
TEMPERATURE. (FLUFF, LOW, or NORMAL).
Overloading restricts tumbling action and results in uneven drying
6. Signal
as well as excessive wrinkling of some fabrics.
End of cycle signal will automatically sound unless you change it
Remember, clothes take up more space as they fluff dry. Proper
by touching SIGNAL ON/OFF Pad.
tumbling is important, so when you dry very small loads, add a few
similar dry items.
7. Start Dryer
Note: If you are using a dryer-add fabric softener, it should be
Touch START/PAUSE Pad. START/PAUSE Pad may also be
added now.
used to pause dudng a cycle to change something or stop in mid
cycle without completely turning off cycle,
Important - See p. 3 for items that should not be dried.
Cycle can be canceled by using OFF Pad.
3. Close The Dryer Door
8. Status Lights lets you know where you are in the cycle.
4. Touch the START/PAUSE Pad to activate the electronic controls.
The pause indicator will light.
9. Stops Automatically
The dryer will alert you to the end of the cycle, unless no signal is
desired. Remove clothes immediately to minimize wrinkling.
NOTE: If a powerfailureoccursduringa cycle,start a new cycle. 1
J
Advertisement
