Advertisement
C_othesT_
T_ L_g
I_
1. Are controls set correctly?
1. Did the Garment Manufacturer's Care Instruction state it could be
dried in a dryer?
2. Is the lint filter clean?
2. Is the garment a knit type that needs to be blocked and pressed
3. Is the exhaust duct installed correctly and free from obstructions?
back into shape?
4. Are there any blown fuses or tripped circuit breakers?
Remember
3. Was the wash temperature too high?
most electric dryers use two.
4. Some shrinkage cannot be prevented.
5. Are clothes sorted properly?
Do not mix heavy and lightweight
articles or towels and permanent press.
I
I
6. Are there too many or too few articles for proper tumbling?
I 5zing
1
1. Does it look like grease?
If so, this could be misuse of fabric
I Writing
I
softener.
To remove rub with bar soap. Wash. Rinse.
I
m
1. Are clothes left in dryer after tumbling stops?
2. Were clothes loaded correctly?
Too many items cause wrinkling.
Too few items - add similar dry item or dry towels to insure proper
1. Were garments overdried?
tumbling.
2. Was a fabric softener used? If not, rewash and dry using a fabric
3. Were clothes sorted correctly?
softener.
4. Were correct wash and dry cycles used?
5. Were clothes allowed to move freely in correct water level when
washing?
6. Was wash temperature too hot?
7. Was a fabric softener used properly to minimize wrinkling?
11
Advertisement
