8.5
JUMP STARTING
When the vehicle batteries do not have suffi cient
charge to start the engine, there are two ways to
start the unit:
1. Coach Batteries:
Depress and hold the switch on the left side
of the dash to connect the coach batteries
into the starter circuit to use all batteries for
starting. Release the switch when the engine
starts. This will remove the battery from the
circuit.
2. Jump Starting:
Open the electrical utility compartment and
connect the jumper cables to the battery
posts. Always connect positive to positive.
The negative should be connected from the
negative terminal of the battery on the vehi-
cle providing the boost to the chassis of the
vehicle needing the boost.
NOTE
See section 10.3.4 for battery
maintenance information.
COMMANDER / EMBASSY
Fig. 8-2 STARTING SWITCH
Fig. 8-3 CHASSIS BATTERY
8-3
Need help?
Do you have a question about the COMMANDER and is the answer not in the manual?