One Pass Scrubbing; Vacuum Only; Adjust Solution Flow - R.P.S. Corporation GTX 26'' Disk Operating Instructions Manual

ONE PASS SCRUBBING:

1. Turn on machine Key Switch (A).
2. Lower the Squeegee by depressing the Squeegee
Switch (G) (Vacuum Motor will turn on automatically).
3. Lower Scrubdeck head to the fl oor by pressing
the Scrubdeck Switch on the Control Panel (D).
4. Press up or down on the Solution Flow Switch
(C) to regulate the amount of solution fl ow.
5. Begin scrubbing by depressing the Foot Pedal
(H) slowly and then to the speed required.
6. Once the machine begins to move, check the down
pressure on the LCD screen. To adjust the down
pressure, push toggle switch (B) forward to increase
pressure backward to decrease pressure. Start
scrubbing at the #1 or #2 marks. Do not use the
#4 or #5 marks without management's approval.
7. To operate the machine in reverse, simply switch
the Reverse switch (E) back towards the rear
of the machine. The reverse speed is set to
approximately 50% of the forward speed.
8. To stop the machine, release the Foot Pedal
and the machine will stop automatically (H).
9. Depressing the green Uni-Touch button
(F) activates the Scrubdeck, Vacuum,
and Squeegee simultaneously.
SCRUB ONLY:
1. Turn on machine Key Switch (A).
2. Lower Scrubdeck head to the fl oor by pressing
the Scrubdeck Switch on the Control Panel (D).
3. Press up or down on the Solution Flow Switch
(C) to regulate the amount of solution fl ow.
4. Begin scrubbing by depressing the Foot Pedal
(H) slowly and then to the speed required.
5. Once the machine begins to move, check the down
pressure on the LCD screen. To adjust the down
pressure, push toggle switch (B) forward to increase
pressure backward to decrease pressure. Start
scrubbing at the #1 or #2 marks. Do not use the
#4 or #5 marks without management's approval.
6. To operate the machine in reverse, simply switch
the Reverse switch (E) back towards the rear
of the machine. The reverse speed is set to
approximately 50% of the forward speed.
7. To stop the machine, release the Foot Pedal
and the machine will stop automatically (H).

VACUUM ONLY:

1. Turn on machine Key Switch (A).
2. Lower the Squeegee by depressing the Squeegee
Switch (G) (Vacuum Motor will turn on automatically).
3. Begin vacuuming by depressing the Foot Pedal
(H) slowly and then to the speed required.
4. To stop the machine, release the Foot Pedal
and the machine will stop automatically (H).
GTX-OP-EN

ADJUST SOLUTION FLOW:

1. Push UP (+) on the Solution Flow switch (C) to
increase the solution fl ow and push DOWN (-) on the
toggle to decrease solution fl ow (SEE BELOW).
G
F
A
B
C
D
E
H
- 19 -