Double Scrubbing - R.P.S. Corporation GTX Series Operator's Manual

Double Scrubbing

Steps: (see picture below)
1. Turn machine on with the key switch.
2. Lower scrub head to the floor, use the
top half of the brush switch.
3. Adjust the solution to the desired
setting. (set half way)
4. Begin scrubbing by depressing the
foot pedal slowly and then to the speed
required. (Not shown)
5. Start scrubbing at the #1 or # 2 marks,
do not use the #4 or #5 marks without
management's approval.
6. To operate machine in reverse,
simply switch the reverse switch to
the reverse position, back up alarm
may sound and your reverse speed
is set to roughly 70% of forward.
7. To stop the machine, let off of the
foot pedal, and the machine will
stop automatically. (Not shown)
5
Operation
Vac Only Scrubbing
1. Turn machine on with the key switch.
2. Lower squeegee by pressing the switch.
3. Begin vacuuming by depressing the
4. To operate machine in reverse,
5. To stop the machine, let off of the
1
2
3
6
PAGE 20
Steps: (see picture below)
foot pedal slowly and then to the speed
required. (Not shown)
simply switch the reverse switch to
the reverse position, back up alarm
may sound and your reverse speed
is set to roughly 70% of forward.
foot pedal, and the machine will
stop automatically. (Not shown)
2
1
4