Table of Contents
Advertisement
"IIP" is a feature unique to VISION security products that
automatically switches from Remote Start Compatibil-
ity Mode to IG Protect Mode when needed. These two
modes are described in detail below. (See Table-1, No.3, on page 16 for
programming.)
When the ignition goes on while the system is armed,
the siren will go off for 30 seconds. Vehicle lights will
flash if so installed. A siren tone will be emitted on the pager, and
icons will update as shown in Fig-8 below. (This mode is the IG Protect
setting shown in No.3 of Table-1 on page 16.)
When the ignition goes on while the system is
armed, the siren will not go off. Instead, shock sen-
sor and ignition triggers are bypassed while door, hood and trunk
triggers remain active. A melody tone will sound on the pager, and icons
will update as shown in Fig-8 below. (This mode is the RSCM setting
shown in No.3 of Table-1 on page 16.)
This feature allows 3rd party remote starters or turbo timer systems to run
the engine without triggering the 1370's siren. The 1370 is still protect-
ing the vehicle, so any attempt to open a door, the trunk or the hood will
trigger the siren. And when the remote starter or turbo timer turns off the
ignition, the shock sensor and ignition triggers are then re-activated. (A
separate pager melody will sound when the Ignition is turned off.)
SYSTEM "ARMED" FEATURES
FIG-8: Pager LCD Icon Change Upon Ignition ON
ST
ON
ACC
OFF
Advertisement
Table of Contents
