Sherwood RD-606i Operating Instructions Manual page 19

RD-606i(A)_ENG_110414_RD-606i(A)_ENG 2011-05-04 오후 2:13 페이지 19
When adjusting the sound parameters
• While playing digital signals form Dolby Digital program source or listening in Dolby Pro Logic II Music mode, you can
adjust their parameters for optimum surround effects.
1.
Press the SOUND PARAMETER button.
• Then "DRC: ~" (or "PANORAMA : ~ ") is displayed for
several seconds.
• If the parameter mode disappears, press this button again.
2.
Press the CURSOR UP(▲)/DOWN(▼) buttons
to select the desired parameter.
PRESET
• Each time these buttons are pressed, the parameter mode
changes as follows:
→"DRC"↔"PANORAMA"↔"C.WIDTH"↔"DIMENSIOM"←
(Dynamic Range
Compression)
• "DRC" can be selected only while playing digital signals
from Dolby Digital source.
• "PANORAMA", "C.WIDTH" and "DIMENSION" can be
selected only while listening in Dolby Pro Logic II Music
mode.
(Center width
control)
3.
Press the CURSOR LEFT(◀)/ RIGHT(▶)
buttons to adjust the selected parameter as
desired.
TUNE
■When selecting the "DRC (Dynamic Range
Compression)"
• This function compresses the dynamic range of
previously specified parts of the Dolby Digital sound track
(with extremly high volume) to minimize the difference in
volume between the specified and non-specified parts.
This makes it easy to hear all of the sound track when
watching movies at night at low levels.
■Note :
• In some Dolby Digital softwares, DRC setting may not be
valid.
→ OFF : To turn off the DRC function. (Default value)
↕
MID
↕
Higher compression
→ MAX
■When selecting the "PANORAMA"
This mode extends the front stereo image to include the
surround speakers for an exciting "wraparound" effect with
side wall imaging.
Select "OFF" or "ON"(default value: OFF).
■When selecting the "C. WIDTH(Center width)" control
This adjusts the center image so it may be heard only from
the center speaker, only from the left/right speakers as a
phantom image, or from all three front speakers to varying
degrees.
The control can be set in 8 steps from 0 to 7(default value :
3).
■When selecting the "DIMENSION" control
This gradually adjusts the soundfield either towards the
front or towards the rear. The control can be set in 7 steps
from -3 to +3 (default value : 0).
4.
Repeat the above steps 2 and 3 to adjust other
parameters.
19