EverFocus KS-KBK Operating Instructions Manual page 72

5.6 Switchers Videotec SM42A, Videotec SM82A, Videotec SM84A
5.6.1 Connection
5.6.1.1 Cable
The communication cable is standard, as described in § Standard connection cable, page 8
5.6.1.2 Switcher sett ings
Switchers Videotec SM42A/Videotec SM82A/Videotec SM84A can be controlled by different types of keyboard
and therefore emulates the respective protocols: to control the switcher with the KS KBK keyboard the MACRO
protocol with baud rate 38400 should be used.
Set the dip switches in the switcher as required (all dips are OFF, with the exception of Macro Protocol, baud
rate 38400, programming).
5.6.1.3 Keyboard set tings
While the keyboard is being set up, the












The presence of two keyboards connected to the switcher means it is necessary to define two different
identification numbers (from 1 to 4).
5.6.1.4 Operational t est
If the keyboard is connected directly with the switcher set up in this way using the telephone cable supplied, it
should be possible to switch the input videos immediately:

• press

• press
5.6.2 Video devic e setup
The setup procedure is described in the video device's instruction manual.

Press to enter setup, and insert setup password if it has been enabled.

Control of a Videotec SM42A switcher
Control of a Videotec SM82A switcher
Control of a Videotec SM84A matrix
to select monitor 1

, , to select the cameras.
Page 22
submenu should be set as follows:
MNECKSKBK_0350