Advertisement
3. Wait until the head cools down.
Preparation for cooling takes approximately 90 seconds. During preparation, the fan
rotates, and the "COOL-AESTHETIC" mode indicator lamp flashes.
When the device is ready to be used, the cooling fan stops, and a ready sound
beeps, and the mode indicator lamp lights.
CAUTION
The cooling fan may not stop even when the device is ready to be used, but this
is to maintain the performance and is not a device failure.
The head does not vibrate in the "COOL-AESTHETIC" mode.
4. While the cooling fan is operating, hold the device so as not to block the suction and
exhaust holes. (Fig.12)
Suction hole
Be careful not to block the suction and exhaust holes in the main body by hand
because if the holes are blocked, the head will not cool down sufficiently.
5. Lightly apply the head directly to your skin, move and pat it slowly following the pattern
of Fig.13.
The mode indicator lamp switches to light. The head does not vibrate.
The usable time is within approximate 90 seconds. When 90 seconds have elapsed,
an automatic stop is made.
Using at the same area for about one second, repeat "applying and releasing" the
head from the center to the outside of your face.
CAUTION
Do not slide the head as it is applied to your skin.
Do not stop the head at the same area of your skin.
The cooling effect of the head weakens.
6. When 90 seconds have elapsed, an automatic stop is made. (Auto-off function)
The ending sound (beep) will indicate automatic stop.
After the end of "COOL-AESTHETIC," the main body and head are slightly hot, but
this is not an abnormality.
7. After use, make sure to pull out the power adaptor from the outlet. (Fig.7)
Wipe toner, etc., if adhering to the head or main body from your skin, with tissue, etc.
During use, the power adaptor may become slightly hot, but this is not a device failure.
CAUTION
If all the mode indicator lamps and level indicator lamps begin to flash and a warning
sound beeps during use, it is a signal to indicate a device failure.
Pull out the power adaptor from the outlet, and request your distributor to make
repairs.
8. After use, give regular skin care with emulsion, cream, etc.
Care for the main body
Wipe the toner or milky lotion off the main body and ring with tissue, etc.
When dirt is difficult to remove, wipe it with a cloth moistened with water and firmly
squeezed.
Do not wash or splash water on it.
(Cause of failure)
Make sure to turn OFF the switch.
(Improperly turning on the switch may cause irritation or malfunction.)
Do not use alcohol, benzine, or thinner.
CAUTION
(Cause of deformation or discoloration)
How to preserve
Preserve in an area with little humidity and dust.
Do not keep this product in places splashed with water or in damp
places, such as in a bathroom. (Cause of short circuit or failure)
Do not wind the cord around the power adaptor or main body.
(Cause of damage to the cord)
Do not keep this product in areas exposed to direct sunlight
CAUTION
(inside of a vehicle, etc.) or near heaters.
(Cause of deformation or discoloration)
Specifications
Power
Power adaptor
100 - 240V AC, 50-60Hz
supply
(KH-186B)
Rated time
Around 18 minutes at the maximum
Accessories
Rings (two)
Disposal of the product
Do not disassemble except when disposing of the product.
This product includes recyclable parts.
For disposal of the parts, observe your local laws and regulations etc.
Advertisement
