Command Control Via The Network - Hitachi CP-AX2503 User Manual

8.4 Command Control via the Network

commands.
Communication Port
The following two ports are assigned for the command control.
(Network Control Port1 (Port: 23))
(Network Control Port2 (Port: 9715))
NOTE
Command Control Settings (
Example: If the IP address of the projector is set to 192.168.1.10:
1) Enter "http://192.168.1.10/" into the address bar of the web browser, and select
Projector Web Control from the selection window.
2) Enter your user name and password, and then click the [OK].
3) Click the [Port Settings] on the main menu.
4) Click the [Enable] check box to open Network Control Port1 (Port: 23) to use
authentication is required, otherwise clear the check box.
5) Click the [Enable] check box to open Network Control Port2 (Port: 9715) to
when authentication is required, otherwise clear the check box.
6) Click the [Apply]
44)
[Enable] check box for the [Authentication] setting when
[Enable] check box for the [Authentication] setting
8. Other Functions
95