Changing A Bulb - Abarth Punto Owner's Handbook Manual

CYLINDER REPLACEMENT
KNOWING
PROCEDURE
YOUR VEHICLE
To replace the cylinder, proceed as follows:
❒ disconnect A-fig. 134;
❒ turn the bottle anticlockwise to replace and raise it;
SAFETY
❒ fit the new cylinder and turn it clockwise;
❒ connect connection A to the canister and fit the
STARTING
transparent tube B in the special compartment.
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
fig. 134
158

CHANGING A BULB

GENERAL INSTRUCTIONS
❒ When a light is not working, check that the
corresponding fuse is intact before changing a bulb.
For the location of fuses, refer to the paragraph "If a
fuse blows" in this section;
❒ before changing a bulb check the contacts for
oxidation;
❒ burnt bulbs must be replaced by others of the same
type and power;
❒ always check the height of the headlight beam after
changing a bulb for safety reasons.
Changes or repairs to the electrical
system (electronic control units) carried
out incorrectly and without due consideration
for the technical specifications of the system
may lead to malfunctioning and generate a fire
hazard.
Halogen lamps contain pressurised gas.
If they break, glass fragments could fly
everywhere.
F0U135Ab
WARNING
WARNING