Hazard Warning Lights; Replacing A Bulb - Abarth 595 Owner's Manual

HAZARD WARNING
LIGHTS
These lights are switched on by
pressing button (1) fig. 102, regardless
of the position of the ignition key.
102
With the device on, warning lights
and light up in the instrument panel.
Press the button (1) again to switch the
lights off.
WARNING The use of hazard warning
lights is governed by the highway
code of the country you are driving in:
comply with legal requirements.
Emergency braking
In the event of an emergency braking,
the hazard warning lights switch on
automatically together with warning
lights and on the instrument
panel.
The lights switch off automatically when
emergency braking ceases.

REPLACING A BULB

GENERAL
INSTRUCTIONS
Before replacing a bulb check the
contacts for oxidation;
burnt bulbs must be replaced by
others of the same type and power;
always check the headlight beam
direction after changing a bulb;
when a light is not working, check
that the corresponding fuse is intact
before replacing a bulb. For the
location of fuses, refer to the paragraph
AB0A0474
"Replacing fuses" in this chapter.
126) 127) 128) 129)
28) 29)
WARNING When the weather is cold or
damp or after heavy rain or washing,
the surface of headlights or rear lights
may steam up and/or form drops of
condensation on the inside. This
is a natural phenomenon due to the
difference in temperature and humidity
between the inside and the outside
of the glass which does not indicate
a fault and does not compromise the
normal operation of lighting devices.
The mist disappears quickly when
the lights are turned on, starting from
the centre of the diffuser, extending
progressively towards the edges.
107