Samsung SNB-6011 User Manual page 14

overview
Rear of the main unit
Item
Power supply
terminal
Network connection
terminal
In/out terminal
Reset Button
Power indicators
Test Monitor Out
14_ overview
Terminal used to connect to the DC12V power adaptor.
Terminal used to connect to PoE or LAN via the RJ-45 cable.
GND Ground terminal.
The terminal sends the alarm output signal.
ALARM OUT
Refer to "Alarm Out Wiring Diagram" (page 23).
The terminal sends the alarm input signal.
ALARM IN
Refer to "Alarm In Wiring Diagram" (page 22).
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
J
If you reset the camera, the network settings will be adjusted so that
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
ON : While the power is on
POWER
OFF : If the power is off
Output port for test monitoring the video output. Use the test monitor cable
to connect to a mobile display and check the test video.
Description