Replacing A Turn Signal Light Bulb; Supporting The Motorcycle - Yamaha Star XV250Y Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
Replacing a turn signal light
bulb
1. Remove the turn signal lens by re-
moving the screws.
1. Screw
2. Remove the burnt-out bulb by
pushing it in and turning it counter-
7
clockwise.
EAU24212
1. Turn signal light bulb
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws. NOTICE: Do not over-
tighten the screws, otherwise
the lens may break.
7-33

Supporting the motorcycle

Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other maintenance
requiring the motorcycle to stand up-
right. Check that the motorcycle is in a
stable and level position before starting
any maintenance. A strong wooden
box can be placed under the engine for
added stability.
To service the front wheel
1. Stabilize the rear of the motorcycle
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack un-
[ECA10681]
der the frame in front of the rear
wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
EAU24350