NOTE: To achieve maximum resolution, distance and EMC compliance, installations must use F/UTP CAT6 or better cable with solid 24 AWG copper wire. The use of lower quality cables will lower overall performance. Please contact tvONE for cable recommendations. Specifications...
NOTE: To achieve maximum performance and compliance, installers must use F/UTP CAT6 or better cable with solid 24 AWG copper wire. Category cabling for the tvONE Magenta HD-One DX/DX500 Series must be pinned to the TIA-EIA T568B wiring specification (See Appendix A). tvONE recommends that all Category cables be pre-terminated and tested.
For best performance, use one continuous F/UTP cable with as few breaks as possible (i.e. patch bays, wall plates, or floor boxes). tvONE recommends mounting and connecting all cables to the HD-One DX/ DX500 Series components before applying power. ...
Connections on the HD-One DX/DX500 Figure 1 shows the HD-One DX/DX500 transmitter connections, and Figure 2 shows the HD- One DX/DX500 receiver connections. Figure 1 - Connections on the Transmitter Figure 2 - Connections on the Receiver Figure 3 - LED Status Indicators on front of both units Figure 3 shows the LED Status Indicators on the front of each unit, both units have the same indicators.
Troubleshooting Common Problems Most issues with the HD-One DX/DX500 Series can be resolved by checking the Category cable terminations and ensuring that they are pinned to the T568B wiring specification. However, other problems may arise. Below are solutions to the most common issues: Problem: No video Solution:...
Need help?
Do you have a question about the Magenta HD-One DX500 and is the answer not in the manual?
Questions and answers