Using The Go7 In An Ap24/Ap28 System; Using The Autopilot In An Evc System; Locking Remote Stations - Simrad GO7 Operator's Manual

Using the GO7 in an AP24/AP28 system

Command transfer
If your GO7 is connected to an autopilot system including an AP24
or AP28 control unit, only one control unit can be active at the same
time. An inactive control unit is indicated with a square with a cross
symbol in autopilot controller pop-up.
You take command from an inactive control unit by selecting the
mode in the autopilot pop-up, and then confirming active mode.

Locking remote stations

The AP24/AP28 includes a Remote Lock function that disables
autopilot control from other units. A locked control unit is indicated
with a key symbol in autopilot controller pop-up.
When the remote lock function is enabled on an AP24/AP28 control
unit, only the active control unit stays in command. No transfer of
command to GO7 or other autopilot control units on the system
can take place.
You can only unlock the remote stations from the AP24/AP28 unit in
command.

Using the autopilot in an EVC system

When the GO7 is connected to an EVC system via the SG05, you can
take manual control of the steering regardless of the autopilot
mode.
The mode indicator on the pilot pop-up is replaced by a dash to
indicate EVC override.
The system returns to GO7 control in standby mode if no rudder
command is given from the EVC system within a predefined period.
71
Autopilot | GO7 Operator Manual