Table of Contents
Advertisement
QSTS CABLE
1. Measure:
Nozzle deflector set length a, b
Difference → Adjust.
Measurement steps:
Set the control grip in the neutral posi-
tion.
Set the jet nozzle in the center posi-
tion.
Measure the nozzle deflector
length a and b.
If a and b length are not even, adjust
the cable joint.
2. Adjust:
QSTS cable
Adjustment steps:
Set the control grip in the neutral posi-
tion.
Loosen the locknut 1.
Remove the nut 2 and pivot pin 3.
Set the nozzle deflector in the center
position.
Turn the cable joint 4 in or out for
adjusting length a and b.
Turn in
Turn out
WARNING
The cable joint must be screwed in more
than 8 mm (0.31 in).
Connect the cable joint 4 and pivot
pin 3 and tighten the nut 2.
Nut:
4 N • m (0.4 kgf • m, 2.9 ft • lb)
Tighten the locknut 1.
Locknut:
4 N • m (0.4 kgf • m, 2.9 ft • lb)
NOTE:
If the QSTS cable cannot be properly
adjusted at the QSTS converter side, make
sure the QSTS cable at the jet pump side is
set to the specified length.
– 18 –
Length b is increased.
Length a is increased.
E
set
Hide quick links:
Advertisement
Table of Contents
