Advertisement
Product Compliance
Electrical Safety
UL 1492:1996: A sample of this equipment has been tested and found to meet the
requirements of UL 1492:1996.
EN 50083-1/A2:1998 and IEC 60065:1998/EN 60065:1998: A notified body has issued a
Certificate of Compliance according to the Low Voltage Directive of February 19,
1973. A sample of this equipment has been tested and found to be in conformity with
EN 50083-1/A2:1998 and IEC 60065:1998/EN 60065:1998.
Electromagnetic Compatibility
FCC Part 76 Subpart K: This equipment has been tested and found to comply with
the limits for Part 76 of the FCC Rules. These limits provide reasonable protection
against harmful interference when operating this equipment in a commercial
environment. This equipment generates, uses, and can radiate radio frequency
energy and, if the user does not install and use this equipment according to the
instruction manual, it may cause harmful interference to radio communications.
EN 50083-2/A2: 1998: According to the provisions of the EMC Directive of May 3,
1989, a sample of this equipment has been tested and found to be in conformity with
EN 50083-2/A2: 1998.
FCC Part 15 Subpart B: This equipment has been tested and found to comply with
the limits for a Class B digital device according to Part 15 of FCC Rules. These limits
are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/television technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
4000254 Rev C
Surge-Gap Drop Amplifier Installation Instructions
7
Advertisement
