XTS 9300S-HDS Series User Manual page 36

To set up preset:
① In the Advanced interface, click preset "Setting" button to see a dialog box as Fig 4-33:
②
In the preset setting tab, enable preset, set the preset name and then click preset
"Setting" button.
③
Control the dome by rotating up, up left, down, right down, left, left down, right and up
right and adjust the rotate speed and the value of zoom, focus and iris of the dome.
④
Select the serial number of the preset point. Click
and click
Note: PTZ must support wiper and light button and these two buttons are just available
when selecting PELCOP or PELCOD.
Fig 4-32 P.T.Z configuration-advanced
Fig 4-33 Advanced-Preset Setting
Fig 4-34 Preset Setting
button to enable the PTZ light.
button to enable the PTZ wiper
31