JVC KD-APD89J Service Manual page 16

3.2.4 Removing the chassis unit
(See Figs.5 and 6)
• Remove the top cover and base board.
(1) From the top side of the CD mechanism assembly, remove
the front suspension springs and rear suspension springs
attaching the chassis unit to the frame. (See Fig.5.)
(2) Remove the chassis unit from the dampers on the frame in
an upward direction. (See Fig.6.)
Note:
• Pay attention to misuse and loss of each spring. (See Fig.5.)
• When reassembling, make sure that the three shafts on the
underside of the chassis unit are inserted to the dampers
certainly. (See Fig.6.)
1-16 (No.MA392<Rev.002>)
Chassis unit
Front suspension spring
Frame
Rear suspension spring
Fig.5
Chassis unit
Shaft
Damper F
Damper F
Fig.6
Front suspension spring
Rear suspension spring
Shaft
Damper R
Frame
Shaft