Skyteam ST 50-6 Operation Instruction Manual page 6

MODIFICATION
Modification of the motorcycle, or removal of
original equipment may render the vehicle unsafe
or illegal. Obey the local regulations for available
equipment.
STEERING STEM REMOVAL
In order to reduce the occupied space, the
motorcycle steering stem can be removed or bent.
Turn off the steering stem tightening wheel (1),
making the locating boss leave the groove, then
bend the lower steering stem as per the direction
shown in the figure, making the boss coincide with
the groove and screwing up the steering stem
tightening wheel. On the contrary, the steering stem
can be returned to its original position.
WARNING
After the steering stem is located, make sure
to screw up the steering stem tightening wheel.
6
SERIAL NUMBER LOCATION
The frame and/or engine serial numbers are
used to register the motorcycle. They are also used
to assist your dealer when ordering parts or
referring to special service information.
The frame number (1) is stamped on the steering
stem head right surface. The engine serial number
is stamped on the left side of crankshaft and the
motorcycle nameplate is stamped on the right side
center of frame.
Please write down the numbers here for your
reference.
7