Connector Tables - digico D5 Live Quick Start Manual

Setup & Installation Manual
Connections.....................................
Worksurface Rear Panel ...............................................................
Function
MADI Audio I/O
Optocore
RS-422 Machine Control
LTC Time Code In
LTC Time Code Out
MIDI In/Out/Thru
AES/EBU Input
AES/EBU Output
Word Clock Input
Word Clock Output
Video Clock Input
External Monitors
External Talkback Mic
Modem
Network
use)
Mains Power
Requires 2 separate mains connections. Mixer will operate on only 1 supply. Supply units can be switched
off, removed and replaced whilst the other is use (hot swappable)
I/O Rack Control Panel .................................................................
Function
MADI I/O
Optocore
Word Clock Out
Word Clock In
Mains Power
I/O Rack Audio Connections ........................................................
The number and type of Rack Modules in each type of rack varies according to requirements. See Stand-
ard Configuration details elsewhere.
Function
Analogue Line Inputs
Analogue Mic Inputs
These modules look identical except for Mic or Line ID label on the panel.
Analogue Line Output
NOTE: Analogue cards are either input or output and these must be fitted in the correct side of the rack.
AES/EBU Input / Output*
TDIF and ADAT modules are optionally available to special order. Contact your dealer or the factory for information.
Page 10
Connector
Female BNC
Stratos HMA
Female D-9
FXLR
MXLR
5 pin DIN
Female XLR
Male XLR
BNC
BNC
BNC
15 pin HD D
15 pin HD D x 4
9-pin D Female
RJ11
RJ45
IEC power x 2
Connector
BNC socket
Stratos HMA
BNC socket
BNC socket
IEC power x 2
Connector
8 x XLR female
8 x XLR female
8 x XLR male
8x XLR
Comments
2 or 4 Pairs of I/O
2 Bidrectional dual connector
Sony P2 Protocol
Balanced, Pin 2 Hot
Unbalanced, Pin 2 Hot
MMC, MTC
Sync input ONLY
Null signal sync output ONLY
External clock input
Clock output follows console (5Vp-p)
House video sync
Overview, adjustable resolution
Ideally use 1280 x 1024 SVGA
Duplicate internal screens
Standard 640 x 480 VGA output
See separate page
See separate page
Ethernet compatible (Not implemented for general
Dual redundant supplies.
250VA (fadrers idle)
300 (all faders active)
90V-260V 50-60Hz auto sense
Comments
2 Pairs of I/O to Console
2 Bidrectional dual connector
48/44.1 KHz 5V p-p
48/44.1 KHz 5V p-p max
Dual redundant supplies.
Stage rack 175VA run
FOH rack 175VA run
90V-260V 50-60Hz auto sense
Comments
8 Channels per card, electronic balanced, Pin 2 Hot
8 Channels per card, electronic balanced, Pin 2 Hot
8 channels per card, electronic balanced, Pin 2 Hot
4 Female (input) + 4 Male (Output) floating balanced