Changing Wheels - Fitting - Volvo XC 70 Owner's Manual

WARNING
Never position anything between the
ground and the jack, nor between the jack
and the car's jacking point.
7. There are two jacking points on each side
of the car. There is a recess in the plastic
cover at each point. Crank the foot of the
jack down so it is pressed squarely on the
ground.
IMPORTANT
The ground must be firm, smooth and
level.
8. Lift the car so that the wheel is free.
Remove the wheel bolts and lift off the
wheel.
Related information
•
Changing wheels - fitting (p. 327)
•
Jack* (p. 322)
•
Warning triangle (p. 329)
•
Wheel bolts (p. 321)
09 Wheels and tyres

Changing wheels - fitting

It is important that the procedure for fitting
the wheel is carried out correctly.
Installation
1. Clean the contact surfaces between
wheel and hub.
2. Put on the wheel. Tighten the wheel bolts
thoroughly.
3. Lower the car so that the wheels cannot
rotate.
4. Tighten the wheel bolts crosswise. It is
important that the wheel bolts are tight-
ened properly. Tighten to 140 Nm. Check
the torque with a torque wrench.
5. Refit any full wheel covers.
*
Option/accessory, for more information, see Introduction.
09
}}
327