PREPARATION OF REMOTE CONTROL
Load the batteries to the groove of the remote control and this will enable you to
operate the STB
1. Open the lid.
2. Load the batteries (AAA type), while installing the batteries match the polarities
on the battery and the corresponding polarity indicated on the remote controller.
3. Close the lid
OPERATION SCOPE OF THE REMOTE CONTROL
Make the remote controller point towards the
inductive window of STB and then press the keys:
1. Distance:
of the inductive window.
2. Angle: about 30 degree right or left refer to the
frontispiece of the native's front panel.
USEFUL TIPS
„ Distance:
about seven meters in front of
1. To prolong the life of this STB, the interval of the continuous switch (Change)
the
action must be more than one minute.
2. The parameter of the power source used should be in accordance with the one
Inductive window
indicated on the rear panel; otherwise the STB will not work properly and can be
„ Angle: about 30 degree right or left refer to
damaged.
the
3. While viewing the picture if the unexpected error occurs and STB becomes non-
responsive, please restart the STB to resume the playback.
Frontispiece of the STB's front panel
4. To get best of the STB performance ensures that adequate signal levels are
maintained.
about
seven
meters
in
front
8