Table of Contents
Advertisement
About the Controls on the Air Conditioner
The controls will look like one of the following:
Controls – Cooling Only
Operation
Off
Med
Fan
Low
Fan
Low Cool
Thermostat
5
4
6
3
2
1
9
• FOR NORMAL COOLING
1. Turn the Operation Knob to the High Cool from
the Low Cool setting.
2. Set the Thermostat control to the desired
temperature mark 5 (the mid-point is a good
starting position). If the room temperature is not
satisfactory after a reasonable time, adjust the
control to a cooler or warmer setting, as
appropriate.
• FOR MAXIMUM COOLING
1. Turn the Operation Knob to the High Cool setting.
2. Set the Thermostat control to the largest 9
temperature mark.
• FOR QUIETER OPERATION
1. Turn the Operation Knob to the Low Cool setting.
2. Set the Thermostat control as needed.
Off
- Turns air conditioner off.
Med Fan - Med speed fan operation without cooling.
High
Cool
Low Fan - Low speed fan operation without cooling.
High Cool - Cooling with high speed fan operation.
Med Cool - Cooling with med speed fan operation.
Low Cool - Cooling with low speed fan operation.
Med
Cool
This automatically controls the temperature of the indoor air.
Turn the knob so that arrow points to the larger marks for
7
greater cooling. Point the arrow to the smaller marks for more
moderate cooling.
(i.e. the higher number, the greater cooling)
8
• ENERGY SAVER (optional)
On : Both the fan and the compressor turn on and
turn off together while operation knob is set to
the Cool position.
You can get the more economical operation.
Off : The fan runs constantly while operation knob is
set to the Cool position.
Energy Saver
Off
You can access the Energy Saver switch when you
open the inlet grille.
6
On
Advertisement
Table of Contents
