Sony CDX-GT210 Service Manual page 2

CDX-GT210/GT212/GT262/GT262S
Ver. 1.2
Power amplifier section
Outputs Speaker outputs (sure seal connectors)
Speaker impedance 4 – 8 ohms
Maximum power output 45 W × 4 (at 4 ohms)
(CDX-GT210/GT212/GT262: EA)
50 W × 4 (at 4 ohms)
(CDX-GT262: IND/GT262S)
General
Output Power antenna (aerial) relay control terminal
Inputs Telephone ATT control terminal
(CDX-GT210/GT212)
Antenna (aerial) input terminal
AUX input jack (stereo mini jack)
Low: ±10 dB at 100 Hz
Tone controls
High: ±10 dB at 10 kHz
Loudness +9 dB at 100 Hz
+5 dB at 10 kHz
Power requirements 12 V DC car battery (negative ground (earth))
Approx. 178 × 50 × 179 mm
Dimensions
× 2 × 7
(7
1/8
Approx. 182 × 53 × 162 mm
Mounting dimensions
× 2
(7
1/4
Mass Approx. 1.2 kg (2 lb. 11 oz.)
Supplied accessories Parts for installation and connections (1 set)
Design and specifications are subject to change without
notice.
• Abbreviation
EA : Saudi Arabia model
IND : Indian model
SERVICE NOTES
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK
OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic
breakdown because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic breakdown and also use
the procedure in the printed matter which is included in the repair
parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, when checking the laser diode emission,
observe from more than 30 cm away from the objective lens.
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS
WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS
MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
2
in.) (w/h/d)
1/8
× 6
in.) (w/h/d)
1/8 1/2
Notes on Chip Component Replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be damaged
by heat.
TEST DISCS
Please use the following test discs for the check on the CD section.
YDES-18 (Part No. 3-702-101-01)
PATD-012 (Part No. 4-225-203-01)
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
If the optical pick-up block is defective, please replace the whole
optical pick-up block.
Never turn the semi-fixed resistor located at the side of optical pick-
up block.
semi-fixed resistor
optical pick-up