Auto Operation - LG EN 61000-2 Owner's Manual

Auto operation

ON
During Auto Operation
❏ You cannot control the indoor fan speed. It has already been set by the Fuzzy rule.
❏ If the system is not operating as desired, manually switch to another mode. The system will not
automatically switch from the cooling mode to the heating mode, or from heating mode to cooling
mode, it must be done by manually resetting.
❏ During Auto Operation, pressing the CHAOS swing button makes the horizontal louvers swing up and
down automatically. If you want to stop auto-swing, press the CHAOS swing button again.
1 Press the Start/Stop button.
The unit will respond with
a beep.
2 Open the door of the remote controller. To select Auto
Operation, press the operation mode selection button.
Each time the button is pressed, the operation mode is
shifted in the direction of the arrow.
Cooling
The temperature and fan speed are automatically set by the
3
electronic controls based on the actual room temperature. If
you want to change the set temperature, press the Room
Temperature Setting buttons. The cooler or warmer you feel,
the more times (up to two times) you should press the button.
The set temperature will be changed automatically.
Operating Instruction
Auto Healthy
Dehumidification
To raise the temperature
To lower the temperature
Owner's Manual 15
Heating
(Heat pump model only)