Panasonic KX-TG6451BX Operating Instructions Manual page 25

TG6451BX(e).book Page 25 Wednesday, July 8, 2009 10:25 AM
3
{V}/{^}: "Register H.set" i M
4
Base unit:
Press and hold {x} for about 5 seconds, until
the registration tone sounds.
L If the registered handset starts ringing,
press the same button to stop. Then repeat
this step.
L The next step must be completed within 90
seconds.
5
Handset:
Wait until "Base PIN" is displayed. i Enter
the base unit PIN (default: "0000"). i M
L If you forget your PIN, contact an authorised
service centre.
L When the handset has been registered
successfully, w stops flashing.
Deregistering a handset
A handset can cancel its own registration that is
stored to the base unit. This allows the handset to
end its wireless connection with the system.
Y Handset
1
8 (middle soft key)
2
{V}/{^}: "Base Unit Setup" i M
3
{3}{3}{5}
4
{V}/{^}: "Cancel Register" i M
5
Select the handset you want to cancel by
pressing the desired handset number. i
M
L The selected handset number flashes.
L To cancel a selected handset number,
press the number again. The number stops
flashing.
6
{V}/{^}: "Yes" i M
L A confirmation tone sounds as the handset
number disappears.
L The handset does not beep when
cancelling its own registration.
7
{ih}
Increasing the range of the base unit
You can increase the signal range of the base unit
by using a DECT repeater. Please use only the
Panasonic DECT repeater noted on page 3.
Contact your Panasonic dealer for details.
Important:
L Before registering the repeater to this base unit,
you must turn the repeater mode on.
L Do not use more than one repeater at a time.
Setting the repeater mode
Y Handset
1
8 (middle soft key)
2
{V}/{^}: "Base Unit Setup" i M
3
{V}/{^}: "Repeater" i M
4
{V}/{^}: Select the desired setting. i M
i {ih}
Note:
L After turning repeater mode on or off, certain
icons displayed on the base unit disappears for
a moment and w flashes on the handset
momentarily. This is normal and the handset can
be used once w stops flashing.
Programming
25