Speaker Connector Installation; Power Led & Key Lock Connector Installation; Turbo Switch Connector Installation; Turbo Led Connector Installation - Gigabyte GA - 586S2 User Manual

Table of Contents

GA-586S2

3.8. SPEAKER CONNECTOR INSTALLATION

There is always a speaker in AT system for sound purpose. The 4 - Pins

connector SPK is used to connect speaker. The speaker can work well in

both direction of connector when it is installed to the connector SPK on

mainboard.

3.9. POWER LED & KEY LOCK CONNECTOR INSTALLATION

There is a system power LED light and a key on the panel of case. The

power LED will light on when system is powered-on, and the key can lock or

unlock the keyboard input, both are connected to a 5 PIN connector. The

connector should be installed to PWR of mainboard in correct direction.

The TURBO switch on the panel is used for controlling the system speed.

Some program developed on XT should be executed with a low speed

system, so a high speed system needs the speed switching function to

change its running speed.

The mainboard uses 60 MHz speed method to implement TURBO switching

function. The TB on mainboard should be connected to the TURBO switch

on panel, and user can push in or pop out the TURBO switch to enable or

disable the turbo function of system.

Please don't use switch ON/OFF when power is ON.

The TURBO LED on panel can indicate the current speed status of system.

The TURBO LED connector should be installed to TD in correct direction.

The RESET switch on panel provides users with HARDWARE RESET

function which is almost the same as power-on/off. The system will do a cold

start after the RESET switch is pushed and released by user. The RESET

switch is a 2 PIN connector and should be installed to RST on mainboard.

3-10

Table of Contents

Show Quick Links

Table of Contents