Intended Use; Operation - DeWalt DCV581H Instruction Manual

2. For long storage, it is recommended to store a fully charged
battery pack in a cool dry place out of the charger for optimal
results.
NOTE: Battery packs should not be stored completely depleted of
charge. The battery pack will need to be recharged before use.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
COMPONENTS (Fig. 2)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. Battery port
B. Vacuum hose
C. On/off button
D. Tank latch
E. Filter (Fig. 5)
FIG. 2
G
H
A
D
I
F. Side exhaust port
G. Hose clip
H. Crevice tool
I. Wide nozzle tool
J. Cord Wrap
C
J
F
B

INTENDED USE

The vacuum is designed to operate only on a D
NiHiD/Li-Ion battery pack, 20V Max* Li-Ion battery pack, or a 120V
AC input. Battery pack and charger are sold separately. The vacuum
will automatically switch between AC and DC modes.
NOTE: The 120V AC power input is only designed to power the
operation of the vacuum and will not charge an installed battery pack.
The vacuum is designed to perform as a wet/dry unit with no
component changes required when changing from wet to dry, or dry
to wet pick up. This vacuum is for household use.
It is recommended that the tank be emptied of any dry contents prior
to being used for wet pick up to facilitate tank cleaning.

OPERATION

WARNING: To reduce the risk of injury, turn unit off,
disconnect it from power source and remove the battery
before installing and removing accessories, before adjusting
or when making repairs. An accidental start-up can cause injury.
Installing and Removing the
Battery Pack (Fig. 3)
NOTE: Make sure your battery pack is fully
charged.
To install the battery pack into the vaccum,
insert/slide battery into battery port (A). Make
sure the battery pack is fully seated.
To remove the battery pack from the
vacuum, press and hold the battery release on
the battery pack and remove battery. To charge
battery, insert it into your D WALT charger.
E
WALT 18V NiCd/
E
FIG. 3
A