Connect And Setup; Speakers - Philips HTD3500K User Manual

p SOUND
Selects a sound mode.
q VOL +/-
Increases or decreases volume.
(Mute)
r
Mutes or restores volume.
BACK
s
Returns to a previous menu screen.
t OK
Confirms an entry or selection.
u Source buttons
AUDIO SOURCE: Selects an audio
•
input source.
RADIO: Switches to FM radio.
•
• USB: Switches to USB storage device.
DISC: Switches to disc source.
•
EasyLink controls
With Easylink, you can control your home
theater and the TV with the following buttons
on your home theater remote control (see
'EasyLink' on page 16).
• (Standby-On): Press and hold to switch
your home theater, TV and the connected
devices to standby.
• (Play/Pause): When a video disc is in
the disc compartment, wake up the TV
from standby, and then play a disc.
6 EN
3 Connect and
setup
This section helps you connect your home
theater to a TV and other devices, and then set
it up.
For information about the basic connections
of your home theater and accessories, see the
quick start guide.
Note
•
For identification and supply ratings, refer to the type
plate at the back or bottom of the product.
•
Before you make or change any connections, make sure
that all devices are disconnected from the power outlet.

Speakers

Position, connect, and set up your speakers for
best surround sound.
Position
Speaker position plays a critical role in setting
up a surround sound effect.
For best results, place your speakers and the
subwoofer as shown below.