5mm
2
B
3
A
1. Stopper base
2. Casing
3. Adjusting knob
1. Feeder box
2. Screw strip
3. Screw guide
1
1. Driving position
Adjusting the driving depth
004177
Depress the stopper base as far as it will go. While keeping it in this position,
1
turn the adjusting knob until the bit tip projects approx. 5 mm from the stopper
base. Drive a trial screw. If the screw head projects above the surface of the
workpiece, turn the adjusting knob in the "A" direction; if the screw head is
counter-sunk, turn the adjusting knob in the "B" direction.
Installing screw strip
002666
Insert the screw strip through the screw guide. Then insert it through the
1
feeder box until the first screw reaches the position next to the driving position.
2
3
002667
7