Transmitter Unit Panel Description - Pro 2 HDMIC6PRO User Manual

TRANSMITTER UNIT PANEL DESCRIPTION

1. Link LED
This LED indicator will flash once Cat.6 cable has been properly
connected between the Transmitter and Receiver unit. Once both
devices are connected and powered up this LED will stop flashing
and stay on to indicate successful connection between Transmitter
and Receiver.
2. Power LED
This LED indicator will activate once the included 5V DC power
adapter has been properly connected between the Transmitter unit
and a power socket.
Note: the LED will blink during the initial power up time during which it
is loading the device firmware.
3. IR Emitter Port
Insert the IR Emitter Cable to this IR port and place the connected IR
emitter module on the IR Extender zone of HDMI source (set-top box,
DVD player or BluRay Player).
Note: Some devices are very particular about IR emitter placement;
success can be achieved by experimenting with emitter location prior
to adhering the emitter to the device.
4. IR Extender Port
Please connect the IR Extender cable to this port. Output device can
now be controlled from the location of this transmitter unit by way of
its original IR remote control or a universal type IR remote control.
5. Power Input Port
Connect 5V DC power supply to this input port.
6. RJ45 Port
Connect a 100Ohm Cat.6 cable between this output port and the
RJ45 input port on Receiver unit.
Note: For best performance, we encourage the use of Stranded
CAT6A shielded cable STP (750Mhz), as a minimum though please
ensure CAT6 UTP (550Mhz) cable is used or poor performance may
result.
7. HDMI Input Port
Connect one HDMI cable between this port and HDMI output port of
the source device (DVD, Set-top box, blue-ray DVD)