Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Brigade CVISC530-4B
Summary of Contents for Brigade CVISC530-4B
- Page 1 Installation Guide BRIGADE Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-845-4641 or visit our www.brigade.ca Professional Freestanding Electric Induction 30”W. Range F21094 EN (030113)
-
Page 2: Table Of Contents
Table of Contents IMPORTANT – Read and Follow! Warnings & Important Safety Instructions _______________________________________________3 • Before beginning, please read these Your safety and the safety of others is Dimensions _________________________________________________________________________6 instructions completely and carefully. very important. Specifications _______________________________________________________________________7 We have provided many important safety Clearance Dimensions (Proximity to Cabinets) ___________________________________________8 •... - Page 3 IMPORTANT– Please Read and Follow! A GFI shall be used if required by NFPA-70 (National Electric Code), federal/state/local DANGER laws, or local ordinances. • The required use of a GFI is normally related to the location of a receptacle with respect to ELECTRICAL SHOCK any significant sources of water or moisture.
-
Page 4: Dimensions
Specifications Dimensions Electric Induction 30”W. Range Induction 30” Range Description CVISC530-4B Overall width 29-7/8” (75.9 cm) Overall height To top of glass frame 35-7/8” (91.1 cm) min. 37” (94.0 cm) max. - 7 / ( 7 5 Legs adjust 1-1/8” (2.9 cm) 8 ”... -
Page 5: Clearance Dimensions (Proximity To Cabinets)
Clearance Dimensions Clearance Dimensions (Proximity to Cabinets) (Wood/Composite Overlay) • This range may be installed directly CAUTION adjacent to existing 36” (91.4 cm) high The bottom of a standard hood should be base cabinets. To prevent possible damage to cabinets 30”... -
Page 6: Electrical Requirements
Electrical Requirements General Information Electrical Requirements • Viking Range Corporation will NOT warranty any problems resulting from GFI READ AND FOLLOW ALL WARNING Moving, Handling, and Unpacking This product is manufactured with the outlets which are not installed properly or AND CAUTION INFORMATION WHEN neutral terminal connected to the cabinet. -
Page 7: Installation
Leg Installation Installation CAUTION To avoid risk of personal injury or product damages, DO NOT use the handle or oven door to lift the oven. Remove door before installation to ensure that it is not used to lift the unit. DO NOT lift or carry the door by the handle. -
Page 8: Electrical Connection (3-Wire)
Electrical Connection (3-wire) Note: If you have a 4-wire connection, see following section for 4-wire connection instructions. WARNING WARNING Electrical shock hazard. Electrical shock hazard. To avoid risk or electrical To avoid risk of electrical shock, shock, personal injury or death; personal injury or death;... -
Page 9: Electrical Connection (4-Wire)
Electrical Connection (4-wire) WARNING WARNING Electrical shock hazard. Electrical shock hazard. To avoid risk or electrical To avoid risk of electrical shock, shock, personal injury or death; personal injury or death; verify grounding product to the frame your appliance has been of the unit may or may not be permitted properly grounded in accordance with through your local codes. -
Page 10: Leveling/Adjustments/Alignment
Leveling/Adjustments/Alignment Measure the four corners in cutout area to For uneven or sloped floors, level unit with Set the high corner of range so that the top of side trim is verify if flooring is level. metal shims only, as the adjustment required may 3/8”... -
Page 11: Final Installation
Anti-tip Device Installation (cont.) ” ” ” 3 / 8 3 / 8 3 / 8 ( 0 . ( 0 . ( 0 . Attach bracket with Check that unit is level side to side mounting hardware provided. and front to back. The side trim must be 3/8” (0.95 cm) above countertop. -
Page 12: Door Replacement And Adjustment
Door Replacement and Adjustment Final Preparation • All stainless steel body parts should be to remove encrusted materials, soak with wiped with hot, soapy water and with a hot, wet cloths to loosen the material, then liquid cleaner designed for this material. use a wool or nylon scraper. -
Page 13: Service & Registration
Service & Registration Notes ________________________________________________________________________________________________________________________________________________________ Only authorized replacement parts may be used in performing service on the appliance. All servicing should be referred to a qualified technician. ________________________________________________________________________________________________________________________________________________________ Contact Viking Range Corporation, 1-888-845-4641, for the nearest service parts distributor in ________________________________________________________________________________________________________________________________________________________ your area or write to: ________________________________________________________________________________________________________________________________________________________...
Need help?
Do you have a question about the CVISC530-4B and is the answer not in the manual?
Questions and answers