Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Brigade CRDSCD230-5B
Summary of Contents for Brigade CRDSCD230-5B
- Page 1 Installation BRIGADE Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-845-4641, or visit us online at www.brigade.ca BRIGADE Freestanding 30” Dual Fuel Self-Clean Sealed Burner Range (030113) F21138 EN...
-
Page 2: Table Of Contents
Table of Contents IMPORTANT– Read and Follow! Warnings & Important Safety Instructions_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 •... - Page 3 IMPORTANT– Read and Follow! DANGER DANGER A GFI shall be used if required by NFPA-70 (National Electric Code), federal/state/local laws, or local ordinances. GAS LEAK HAZARD CHEMICAL HAZARD • The required use of a GFI is normally related to the location of a receptacle with respect to To avoid risk of property To avoid risk of personal injury any significant sources of water or moisture.
-
Page 4: Dimensions
Dimensions Specifications Dual Fuel 30” W. Range Dual Fuel 30” W. Range Description CRDSCD230-5B Overall width 29-7/8” (75.9 cm) - 7 / ( 7 5 8 ” Overall height To top of side trim – 35-7/8” (91.1 cm) min. 37” (94.0 cm) max. -
Page 5: Clearance Dimensions (Proximity To Cabinets)
Clearance Dimensions Clearance Dimensions (Proximity to Cabinets) (Wood/Composite Overlay) • This range may be installed directly • Wall cabinets above the range must be a The bottom of a standard hood should be adjacent to existing 36” (91.4 cm) high minimum of 42”... -
Page 6: Electrical & Gas Requirements
Electrical & Gas Requirements Electrical & Gas Requirements Electrical Requirements In Massachusetts: Flexible Connections: In Canada: A “T” handle type CAN 1-6, 10-88 metal Check your national and local codes manual valve must be installed in the gas If the unit is to be installed with flexible connectors for gas appliances and regarding this unit. -
Page 7: General Information
General Information Installation NOTICE READ AND FOLLOW ALL WARNING Moving, Handling, and Unpacking DO NOT use the handle or oven door to AND CAUTION INFORMATION WHEN Remove and discard all packing materials, lift the oven. Remove door before INSTALLING THIS APPLIANCE. including cardboard and tape on the outside installation to ensure that it is not used to and inside of the range. -
Page 8: Leg Installation
Leg Installation Electrical Connection (3-wire) Note: If you have a 4-wire connection, see following section for 4-wire connection instructions. WARNING WARNING ELECTRICAL SHOCK ELECTRICAL SHOCK HAZARD HAZARD To avoid risk or electrical To avoid risk of electrical shock, shock, personal injury or death; personal injury or death;... -
Page 9: Electrical Connection (3-Wire)
Electrical Connection (3-wire) Electrical Connection (4-wire) (cont.) Bare Wire Connection Eyelet Connection WARNING WARNING ELECTRICAL SHOCK ELECTRICAL SHOCK HAZARD HAZARD To avoid risk or electrical To avoid risk of electrical shock, shock, personal injury or death; personal injury or death; verify grounding product to the frame of the unit your appliance has been properly may or may not be permitted through... -
Page 10: Leveling/Adjustments/Alignment
Electrical Connection (4-wire) Leveling/Adjustments/Alignment (cont.) Bare Wire Connection Eyelet Connection Feed supply cord up through hole in bottom Measure the four corners in cutout area For uneven or sloped floors, level unit with metal shims To make a bare wire connection, use holes on the left to verify if flooring is level. -
Page 11: Anti-Tip Device Installation
Leveling/Adjustments/Alignments Wall Mount Anti-tip Installation (cont.) (cont.) 3 - 5 3 - 5 3 - 5 ( 9 . ( 9 . ( 9 . ” ” ” ( 1 . ( 1 . ( 1 . / 2 ” / 2 ”... -
Page 12: Connecting Gas & Electrical
Floor Mount Anti-tip Installation Final Installation (cont.) Remove two screws from back of range. Attach bracket to back of range using two screws. Slide range into place. Be sure Burner heads and burner caps are packed in the anti-tip bracket slides into the anti-tip opening. cardboard top pack with the grates. -
Page 13: Door Replacement And Adjustment
Door Replacement and Adjustment Final Preparation • All stainless steel body parts should be to remove encrusted materials, soak with wiped with hot, soapy water and with a hot, wet cloths to loosen the material, then liquid cleaner designed for this material. use a wool or nylon scraper. -
Page 14: Service & Registration
Service & Registration Only authorized replacement parts may be used in performing service on the appliance. All servicing should be referred to a qualified technician. Contact Viking Range Corporation, 1-888-845-4641, for the nearest service parts distributor in your area or write to: VIKING RANGE CORPORATION PREFERRED SERVICE 1803 Hwy 82W...
Need help?
Do you have a question about the CRDSCD230-5B and is the answer not in the manual?
Questions and answers