Panasonic Lumix DMC-LZ10 Operating Instructions Manual page 114

Others
Troubleshooting
lil'1
mI!f<\;~~l:!lIIIl!i!ll1Iml:lilelJlll!l ~~~~~~BIli'S1!!IiIIiI'
i1ilIIIl
I .UlWi!l!.lI'~'I!!IIM_~~Im
• • · l!i1.aIll>WiII.!._ _ IIIIIIl!l!lI_ _
I.m'li'l!~~
If you put the menu back to the settings at the time of purchase, the conditions may be
improved. Carry out the [RESET] in the setup menu while the camera is in the recording
mode. (P23)
• Batteries and power supply
Conditions Causes
. .
The camera turns off The remaining battery power may not be displayed
immediately even when accurately, and the camera may suddenly stop working, when
battery power is full. the type of battery and the settings on [BATIERY TYPE] are
The remaining battery
not identical. However this is not a malfunction. Depending
power is low even if new on the battery brand and the operating temperature, or if
batteries are inserted.
exhausted batteries are used, the remaining battery power
may not be displayed accurately.
Please check [BATTERY TYPE] (P21) in the [SETUP] menu.
The camera will not turn Are the batteries inserted correctly?
on.
Use sufficiently charged batteries when using Ni-MH
batteries.
The picture is not Is the economy mode (P22) activated? Press the shutter
displayed on the LCD button halfway to deactivate these modes.
monitor.
Are the batteries exhausted? Replace them with batteries
which have sufficient capacity. (When you use Ni-MH
batteries, charge them.)
The camera turns off
• Are the batteries exhausted? Replace them with batteries
soon after turning it on. with sufficient charge. (When you use Ni-MH batteries,
charge them.)
• If you leave the camera on, the battery will be exhausted.
Turn the camera off frequently by using economy mode
(P22) etc.
• Shooting
Conditions Causes
The picture cannot be Is the mode correctly set?
recorded.
Is there any memory capacity left on the built-in memory or
the card?
Before recording, delete some pictures. (P38)
The recorded pictures The picture can become whitish if there is dirt e.g. fingerprints
are pale. on the lens. If the lens is dirty, turn on the camera, eject the
lens barrel and gently wipe the lens surface with a soft dry
cloth.
The recorded picture is Check that the exposure is correctly compensated. (P48)
too bright or dark.
2 or 3 pictures are taken Is auto bracket (P49), [HI-SPEED BURST] (P60) or burst
at one time. (P75) mode set?
114