Installing Tubing Into Fittings; Sanitize The System; Installing Tubing Connections - Canature RO 75 GPD 4 STAGE Installation And Operation Manual

Reverse osmosis system

Hide thumbs

Table Of Contents

Table of Contents

Step 1

Cut the tube square and remove burrs and sharp edges. Ensure that the

outside diameter is free from score marks. For soft or thin walled plastic

tubing we recommend the use of a tube insert.

Step 2

Push the tube into the fitting and up to the tube stop

Pull on the tube to check that it is secure. Test the system before use.

Step 3

Sanitize the System (Recommended)

Sanitizing is recommended immediately after installation of the Reverse Osmosis system. It's also recom-

mended after servicing inner parts. It is important that the person installing or servicing the system have clean

hands while handling inner parts of the system.

1. Turn off the water supply to the RO system and close the ball valve on the storage tank.

2. Open the RO faucet.

3. Use an eyedropper (not included) and common household bleach (5.25%).

4. Add 3 ml (1 teaspoon) of bleach into open end of 3/8 tube connected to tank. Handle bleach according to

bleach manufacturer's recommendations.

5. Connect tubing back to tank ball valve.

6. Sanitizing the system will be completed during the Flush System and Check Operation steps on the follow-

ing page.

Note: The bleach must be removed from the system before drinking the water. See Flush System

instructions on the next page.

With all components in place, complete final tubing

connections using these guidelines:

 Tubing should follow contour of the cabinets

 Cut tubing to desired length using square cuts and

proper cutting device

 Make no sharp bends

 Keep tubing from the post-filter to the faucet as

short as practical for good flow.

 Leave enough tubing that the system can easily be

pulled out from the cabinet for easy filter changes.