Table of Contents
Advertisement
Quick Links
IPR20 Quick Start Guide
The IPR20 is a 2 Port VoIP Gateway. IPitomy's IPR20 connects two
analog phones to your IP network to allow VoIP calls or allows you to
setup a dedicated DID for faxing. The IPR20 comes with 2 FXS ports,
one WAN port and one LAN port.
5 Easy Steps to configure the IPR20
1)
2)
3)
4)
Creating users on the IPR20
5)
(Optional) Configuration of DID on the PBX for fax service
www.ipitomy.com | 941.306.2200
Advertisement
Table of Contents
Related Manuals for IPitomy IPR20
Summary of Contents for IPitomy IPR20
- Page 1 The IPR20 is a 2 Port VoIP Gateway. IPitomy’s IPR20 connects two analog phones to your IP network to allow VoIP calls or allows you to setup a dedicated DID for faxing. The IPR20 comes with 2 FXS ports, one WAN port and one LAN port.
- Page 2 IPR20 LED Indicators Label Description 10/100 Ethernet Link Up Link Down Flashing Sending / Receiving Data Packets Loop / Ring FXS Phone 1 Off Hook FXS Phone2 On Hook Flashing Ring Out Device Power Indicates Power Supply is Working IPR20 Back Panel...
- Page 3 Typical Small Office Configuration...
- Page 4 If the main network is already a 192.168.1.xxx network you must change the LAN subnet of the IPR20. Leave the WAN side set to DHCP or assign the WAN port a static IP address on the main network. After configuring the IP scheme of the IPR20:...
- Page 5 Log into the IPitomy PBX Under Destinations > Extensions click add new Configure an extension or 2 extensions for the IPR20 (see PBX manual for how to configure extensions) leave phone type as generic and make note of your USERNAME and SIP PASSWORD...
- Page 6 Registering the IPR20 with the PBX Log into the IPR20 ex (192.168.1.1) if you are on the LAN side (DHCP address or static address if on WAN side) Go to SIP > Server *Address, Domain Name and Outbound Proxy IP are the IP address of the PBX to be registered with...
- Page 7 *User Name is the extension number used for this user *Password is the sip password configured in the PBX Save SIP Settings Restart IPR20 The status light on the IPR20 should be solid green if a connection to the PBX was established...
- Page 8 DID please refer to the PBX documentation) Under the destination drop down list for you DID choose the extension created for the user on the IPR20 that will be connected to the FAX machine Set the destination and Save Changes > Apply Changes...
Need help?
Do you have a question about the IPR20 and is the answer not in the manual?
Questions and answers