Water Connection - Venini GED45S Instruction Manual

WARNING!
WARNING!
Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run into the sink, making sure to
avoid bending or crimping. Use the special plastic support that comes wi th the appliance. The free end of the hose
must be at a height between 40 and 100cm and must not be immersed in water.
DISHWASHER
Inlet pipe connector Drain pipe connector
FRONT VIEW
Improper connection of the equipment earthing conductor can result in the risk of an
for personal safety:
electric shock.
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE.
Check with a qualified electrician or service representative if you are in doubt whether the
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE
appliance is properly earthed.
CONNECTION FROM THE POWER CORD.
Do not modify the plug provided with the appliance. If the plug does not fit properly to the
outlet, please have a qualified electrician to install a proper outlet.
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the
water run to make sure that the water is clear. This precaution is needed to avoid the
risk of the water inlet to be blocked and damage the appliance.
The water supply to the appliance can also be connected to the household hot water
line (such as, central system, heating system),as long as it does not exceed a
temperature of 60 C. In this case, the wash cycle time will be shortened by about 15
minutes and the wash efficiency slightly reduced.
The connection must be made to the hot water line following the same procedures as
described in the section for the connection to the cold water line.
In order to avoid that there is more water staying in the inlet hose, please close
the hydrant after using.(Not applicable to appliances wit hout aqua-stop.)
SINK
P O W E R O U T L E T
Min 100mm
17
EARTHING