Turning On The Appliance - Venini GED45S Instruction Manual

Starting a wash cycle...
NOTE:
If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the
main power and water supply before calling a service.
A forgotten dish can be added at any time before the detergent cup opens.
1
Open the door a little to stop the washing.
2
After the spray arms stop working, you can open the door
completely.
It is dangerous to open the door when washing,because the hot water may scald you.
When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handl ing the di shes and utensils while they
are still hot and more susceptible to breakage. They will also dry better.

Turning on the Appliance

Draw out the lower and upper basket, load the dishes and
1
push them back. It is commended that loading the lower
basket first, than the upper one (see the section entitled
"Loading the Dishwasher").
2
Pour in the detergent (see the section entitled "Salt,
Detergent and Rinse Aid").
Insert the plug into the socket. The power supply is 220-240
3
VAC 50 HZ, the specification of the socket is 10 A 250 VAC.
Make sure that the water supply is turned on to full pressure.
When select 6 kinds of wash program
4
Press the programme button, the wash program will change as follows direction
When a program is selected, the response light will light. Then press the
Start/Reset button, the program is running.
Note: When you press the Start/Reset button to pause during washing,
the program light will stop blinking and the dishwasher will mooing
every minute unless you press the Start/Reset button to start.
Premise: You can modified the washing program, just
the dishwasher has been running for a short time.
the detergent may have already been released, and the appliance
may have already drained the wash water. If this is the case, the detergent
dispenser must be refilled (see the section entitled " Loading the
Detergent " ).
Press start/Reset Button more than three seconds the machine will
be in stand by state ,then you can change the program to
the desired cycle setting (see the section entitled " Starting a wash cycle. . . " ).
NOTE: If you open the door when washing, the machine
will pause. When you close the door and press the start/reset Button,
the machine will keep on working after 10 seconds.
The program lights shows the state of the dishwasher:
a) All program lights off---------------stand by
b) One of the program lights on----------pause
c) One of the program lights blinking----- run
3in1->Intensive->Normal->Eco->Rinse->Glass->Rapid->Soak;
3
Load the forgotten dishes.
4
Close the door, the dishwasher will start running again
after 10 seconds.
13
Otherwise,